Check compatibility
If the cellophane tape adheres firmly to the place where you want install it,
it can be used.

compatibility table 1

Notes on use (earthquake-resistant pads)

After installation, do not touch the product for at least 2 hours in order to stabilize the adhesion.

Be sure to remove the protective film.

Do not suspend objects with this product.

Cannot be used on water-repellent materials such as fluoroplastic-coated surfaces.

This product can be used in areas where cellophane tape adheres firmly.

This product is not edible.

The product may discolor over time, but this does not affect its basic performance.

Use in an environment with temperatures above 50℃（122℉） and humidity above 60% may shorten the service life of the product.

After removal, depending on the material, there may be a difference between the installation area and surrounding area. (Materials refer to decorative laminates, wood, stone, etc.)

Chemical reactions may occur on materials with paints containing zinc-based materials.

Discoloration or deformation may occur when used on products containing chlorine, such as chlorine bleach.

This product is designed to minimize earthquake damage. We are not responsible for any damage or loss caused by the use of this product, including damage caused by earthquakes.

Store in a cool, dry place away from direct sunlight and high humidity.

Keep the protective film attached.

When reusing the product, be sure to rinse it in water and dry it completely before use.

If oil or dust cannot be removed by washing with water, wash with a neutral detergent.

Strong acidic or alkaline detergents may reduce the adhesive strength.

If dust, oil, etc. remain after washing, adhesive strength may be reduced.

Please do not peel off the earthquake-resistant pad abruptly to prevent damage to the installation surface and the installed object.

To remove lightweight objects, grasp them firmly and gently rotate them while pulling them upwards.
If the pad is difficult to remove, apply a neutral detergent to a spatula or plastic card, wet it with water, and insert it between the mat and the floor to remove it.
Depending on the material of the installation surface, discoloration, stains, peeling, and scratches caused by tools may occur. Always test in an inconspicuous area before proceeding with the work.

The removal card mentioned below is included with products ”L-Shaped Plastic Bracket” and “Safety Strap for TV”.